Product Specifications
-
Quantity: 4 Pieces
-
Material: High-quality EPDM Rubber with a brass threaded insert
-
Thread Size: M5 x 0.8mm (Standard Metric)
-
Grip Range: Typically fits panels 0.4mm to 4.9mm thick
-
Required Hole Size: Approximately 10mm (fits most standard fairing mounts)
Key Features
-
Vibration Isolation: The flexible rubber body absorbs engine and road vibrations, preventing plastic panels from cracking or rattling.
-
Corrosion Resistant: The internal brass insert and EPDM rubber outer casing are resistant to water, oil, and road grime.
-
Blind Fastening: Ideal for "blind hole" installations where you cannot access the back of the panel to hold a traditional nut.
-
Sealing Properties: When tightened, the rubber expands to create a tight, weather-resistant seal against the mounting surface.
Installation Guide
-
Insert: Push the rubber nut into the pre-drilled hole until the flange is flush against the surface.
-
Align: Place your component (e.g., a windscreen or bracket) over the nut.
-
Tighten: Thread an M5 bolt into the brass insert. As you tighten, the rubber "bunches up" on the back side of the panel, locking the assembly firmly in place.
-
Note: Do not over-tighten; the rubber should be compressed enough to hold firmly without distorting the flange.